Subject	Yea Greg said they have better results on
Posted by	Nis300owner on March 27, 2014 at 6:30 PM
	This message has been viewed 677 times.
In Reply To	Re: 'Search' is your friend. posted by DC3843 on March 27, 2014 at 10:53 AM
Message	The 63s. I'm more worried about them being maxed out Created my dream
Follow Ups	whos running GTX2863's? - Nis300owner 22:31:04 03/26/14 'Search' is your friend. - The Hawk 10:08:21 03/27/14 Re: 'Search' is your friend. - DC3843 10:53:31 03/27/14 Yes, I saw that. Congrats. - The Hawk 13:48:43 03/27/14 Yea Greg said they have better results on - Nis300owner 18:30:37 03/27/14 Going e85 full 2.5" kit, selin intake etc (n/m) - Nis300owner 18:29:07 03/27/14 There is no 'right' turbo, not without stating your goals - JaffaUK 11:19:36 03/27/14 Re: There is no 'right' turbo, not without stating your goals - Nis300owner 18:24:28 03/27/14 I just installed my GTX2863's - SammybTT(TN) 12:33:32 03/27/14 Thank you looking forward to hear what you think (n/m) - Nis300owner 18:27:49 03/27/14 Gt28rs .63 is the smallest turbo I'd run - Jason300zxTT 13:41:57 03/27/14 Bigger to what? Not many options (n/m) - Nis300owner 18:26:47 03/27/14 If ET is your goal, you're going down a difficult path with - SirpriZ 18:40:45 03/27/14 compared to what? - Antihero 19:19:48 03/27/14 Lag on a dyno tells only part of the lag equation. - SirpriZ 19:36:07 03/27/14 Exactly....thats why u build boost at the line. - The Hawk 20:42:27 03/27/14 Before I get killed, I meant with a manual trans. (n/m) - SirpriZ 19:25:32 03/27/14 Thats why 2 steps exist - Zvil (FL) 10:22:25 03/28/14 A two step "should" help a big turbo car improve it's ET. - SirpriZ 12:15:45 03/28/14 If ET's are your end goal, I'd say you want power..... - The Hawk 20:48:22 03/27/14 I'm Running GTX63's - Cutting Z Edge 21:46:25 03/27/14 Re: I'm Running GTX63's - Cutting Z Edge 22:31:14 03/27/14 we have very similar set ups - Nis300owner 22:51:56 03/27/14 Re: we have very similar set ups - Cutting Z Edge 23:11:17 03/27/14 Re: Re: we have very similar set ups - Cutting Z Edge 23:16:03 03/27/14
Post a Followup	You cannot reply to this message because you are not logged in.