Subject	I have plans to do this with my build
Posted by	stellar495 on March 21, 2014 at 10:13 PM
	This message has been viewed 944 times.
In Reply To	Anyone ever make their fuel line feed from pump w/hardline? posted by KongZTT GT28RS MD on March 21, 2014 at 04:46 PM
Message	I have used stainless tubing for fuel lines many times on vintage hot rods and muscle car restorations. You can get insulated/cushioned mounting clamps to prevent chaffing. As long as the lines are routed and secured properly, chaffing shouldn't be an issue. Sections of flexible hose should be used at any points that can move independantly of each other. You will also need a good tubing bender, cutter, and a quality flaring tool with the proper dies for AN flares. I have a hydraulic flaring tool that makes the job much easier. On my Z, I plan to run 1/2" supply and 3/8 return SS tubing in place of the OE hard lines and I will use PTFE braided sections with AN fittings to connect the hard lines to the fuel pump module, fuel filter, and pressure regulator.
Follow Ups	Anyone ever make their fuel line feed from pump w/hardline? - KongZTT GT28RS MD 16:46:34 03/21/14 Re:  Anyone ever make their fuel line feed from pump w/hardline? - JSD-ZX 19:17:50 03/21/14 I have plans to do this with my build - stellar495 22:13:10 03/21/14 which flaring tool do you have? (n/m) - aliaZ 06:48:51 03/22/14 I've done it before - aliaZ 06:20:45 03/22/14 I wondered the same thing.... - The Hawk 12:56:47 03/22/14 I meant from vibration.. if there are spots where - KongZTT GT28RS MD 14:50:37 03/22/14 these guys make custom hardline clamps - aliaZ 17:30:58 03/22/14 Just use adel clamps (n/m) - Dallas DamonZ 10:10:38 03/24/14 Yes and it came out great. look up "Swagelock" fittings - Turbodog (CT) 09:28:44 03/23/14 Re:  Anyone ever make their fuel line feed from pump w/hardline? - Bigwill837 13:25:59 03/23/14
Post a Followup	You cannot reply to this message because you are not logged in.