Subject	Just got my suspension powdercoated.....
Posted by	Zsgetyoulaid on March 20, 2014 at 1:18 AM
	This message has been viewed 1070 times.
Message	Went and dropped of my suspension to get powdercoated at Pristine Powder Coating in Denver, CO. I told the guy I needed it done before I left the country and he assured me it wouldnt be an issue. Well, it ended up being an issue to say the least. He wasnt able to deliver on time, and I told him it wasnt a huge deal because I wouldnt be able to drive the car now anyway since Im out of the country. I dropped off the suspension in December. The suspension JUST got completed. If you have 3 months to do a 1 week job, this place is an attractive option. Otherwise, Id go elsewhere. I think the finish came out nicely and the price was very reasonable. Pics: Now, I *do* have a slight concern. The bushings....As far as I can tell, the rubber portion looks like its in the same condition as when I dropped it off. But there is clearly poweder coating on the cylindrical pin in the center. Is this something I should be concerned about and address? Pic:
Follow Ups	Just got my suspension powdercoated..... - Zsgetyoulaid 01:18:04 03/20/14 You might have a hard time putting the pin in, I would - YlwPrlZTT 01:25:53 03/20/14 I have some brake cleaner on hand back home - Zsgetyoulaid 01:53:59 03/20/14 Brake cleaner isn't strong enough. Gasket remover eats paint (n/m) - ttsmokin 12:45:39 03/20/14 Aircraft paint stripper - Shiers69 14:42:41 03/20/14 Re: Just got my suspension powdercoated..... - DbestiZ1 08:46:59 03/20/14 Its collegeboys old setup - Zsgetyoulaid 10:06:01 03/20/14 Is it ok to do the springs? - Woody75 (Denver) 11:03:32 03/20/14 Re: Is it ok to do the springs? - Zsgetyoulaid 11:22:34 03/20/14 I wouldn't be surprised if the coating cracks on the springs - fuzzymonkey 11:58:43 03/20/14 If it's a single coat, and not laid on too thick, it should - black300zx 17:59:28 03/20/14 You can always have them redone. It's not very expensive (n/m) - Zsgetyoulaid 22:15:44 03/20/14 Powder coating springs won't hurt them. - LitlElvis 13:55:50 03/20/14 looks kinda weird with no contrast (n/m) - Antihero 19:36:13 03/20/14 agreed - Zsgetyoulaid 22:10:05 03/20/14 Pristine did mine. Being a one man shop he does take awhile - ShakaShaun(Denver) 20:30:51 03/20/14 I had my entire engine bay done by blue flame - Zsgetyoulaid 22:13:58 03/20/14
Post a Followup	You cannot reply to this message because you are not logged in.