Subject	Bernie wins, one was bottomed out
Posted by	ThisIsSparTTa on March 17, 2014 at 4:41 PM
	This message has been viewed 172 times.
In Reply To	If you over crush the gaskets you can cause a leak. posted by Bernie (NoVA) on March 16, 2014 at 07:52 PM
Message	I'm working on the drivers side EGR block plate. The inner one has a bottom, the outer one doesn't. I took the outer off first, and sure enough the plate was pretty loose. Somehow that bolt was a bit longer than the one being used on the outside. Not sure if I mixed them up or what. Still going to use some RTV to be sure, but I think that was the issue.
Follow Ups	Anyone had EGR Block Plates leak? - ThisIsSparTTa 19:17:02 03/16/14 Is this a recent installation? Did you install OE gaskets? (n/m) - MixManMash 19:36:23 03/16/14 1+ years ago. Used the gray gaskets that came with (n/m) - ThisIsSparTTa 19:41:37 03/16/14 If you over crush the gaskets you can cause a leak. - Bernie (NoVA) 19:52:50 03/16/14 Not sure, bolts went on a while back - ThisIsSparTTa 08:40:52 03/17/14 Bernie wins, one was bottomed out - ThisIsSparTTa 16:41:29 03/17/14 If the gasket is seated this time, the RTV isn't needed (n/m) - Bernie (NoVA) 17:13:12 03/17/14
Post a Followup	You cannot reply to this message because you are not logged in.