Subject	It's been tested to do very well
Posted by	BlackholeZ on March 02, 2014 at 7:48 PM
	This message has been viewed 233 times.
In Reply To	Anyone try 50/50 acetone-atf to free up bolts/nuts? >> posted by stockplayerz(nyc) on March 02, 2014 at 09:02 AM
Message	[ http://www.fifthaveinternetgarage.com/tech_tips/tech_tips_penetrating_oil.html ] I'd try some heat, but be careful. Are you using flare nut wrenches? -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Anyone try 50/50 acetone-atf to free up bolts/nuts? >> - stockplayerz(nyc) 09:02:08 03/02/14 A little heat might help..don't over do it though. (n/m) - CmyZ 16:19:43 03/02/14 It's been tested to do very well - BlackholeZ 19:48:44 03/02/14 Little heat goes a long way use propane (n/m) - John (MD) 21:40:42 03/02/14
Post a Followup	You cannot reply to this message because you are not logged in.