Subject	Anyone try 50/50 acetone-atf to free up bolts/nuts? >>
Posted by	stockplayerz(nyc) on March 02, 2014 at 9:02 AM
	This message has been viewed 298 times.
Message	Having the hardest time removing the rear small nipple going into the BMC. Starting to round off the 10mm nut, and I've liberally applied PB Blaster for the past hour. Vice grips making it worse. Read the acetone/atf mix works better? Any other tips? TIA.
Follow Ups	Anyone try 50/50 acetone-atf to free up bolts/nuts? >> - stockplayerz(nyc) 09:02:08 03/02/14 A little heat might help..don't over do it though. (n/m) - CmyZ 16:19:43 03/02/14 It's been tested to do very well - BlackholeZ 19:48:44 03/02/14 Little heat goes a long way use propane (n/m) - John (MD) 21:40:42 03/02/14
Post a Followup	You cannot reply to this message because you are not logged in.