Subject	FYI, you don't have to disconnect AC during engine pull
Posted by	bartz32tt on January 27, 2014 at 11:28 AM
	This message has been viewed 364 times.
In Reply To	WS wiring harness install with engine/trans still in car. I posted by Haasz32 on January 27, 2014 at 10:57 AM
Message	You just unbolt the compressor from the engine mounting bracket and tie it off to the side in the bay - all lines are still intact. ________________Sig Separator________________________ Parting out my entire 1990 twin turbo! Please email me for needed parts! See profile for my WTB/WTT list as well.
Follow Ups	WS wiring harness install with engine/trans still in car. I - Haasz32 10:57:07 01/27/14 Nice!!!! We're you able to put back all the - TTZ2NV(EPTmotorsports) 11:11:08 01/27/14 I didn't get all every bracket back the same as it was. - Haasz32 11:29:33 01/27/14 Yes it is possible. It will take a lot of patience and - ZXRider 12:28:05 01/27/14 I've also done it... - vorpalZ 11:11:59 01/27/14 I must have got lucky since I was able to get - ZXRider 12:27:16 01/27/14 2nd. When I reinstalled the new harness, I was - 300MPH 13:04:12 01/27/14 must have run out of patience at that point - vorpalZ 13:47:16 01/27/14 Same here: plenum on, EGR in place, BMC in place, etc. - Haasz32 14:01:43 01/27/14 I got mine on too, but I dont recall if I completely removed - LJZTT 14:32:39 01/27/14 I was definitely out of patience too. I had the - 300MPH 15:57:26 01/27/14 FYI, you don't have to disconnect AC during engine pull - bartz32tt 11:28:02 01/27/14 OK, that's good to know for when I do need to pull the - Haasz32 11:31:54 01/27/14 If you do have to drain freon, check out R12a - ThisIsSparTTa 12:56:13 01/27/14 I did it once, never do it again - ZXRider 12:29:12 01/27/14 How did you get the subharnesses through the firewall? - type993 12:51:18 01/27/14 De-pin the white connector - ZXRider 12:55:15 01/27/14 Yeah that's what I figured.. - type993 13:56:46 01/27/14 I have the version where the white sub-harness has the quick - Haasz32 13:21:40 01/27/14 According to Bernie that grey box is a loop block - ZXRider 13:45:25 01/27/14 Yeah, I wonder if it isn't the same principle as the wire - Haasz32 13:57:10 01/27/14 I have never had trouble getting them through the FW (n/m) - Bernie (NoVA) 04:47:20 01/28/14 I got the initial EFI version (before WS fixed it) :( (n/m) - type993 14:04:41 01/27/14
Post a Followup	You cannot reply to this message because you are not logged in.