Subject	I tried too. Just couldn't find a clean way of cutting them
Posted by	Evan_Wright (Ca) on January 17, 2014 at 3:20 PM
	This message has been viewed 180 times.
In Reply To	easier said than done posted by LJZTT on January 17, 2014 at 01:51 PM
Message	up and still be able to re-seal the cut outs. I know its a lot of work to remove the covers to adjust them but that's what I settled on since I really have no reason to get in there often. Only problem is I had mine removed for my tuning session at SZ last August and I've been too lazy to put them back on.
Follow Ups	Mass produced timing cover? - 280ZuL8r 20:58:40 01/16/14 I see no timing cover here (n/m) - Zvil (FL) 21:00:29 01/16/14 Covering top of cam gears and belt, Yolo? - 280ZuL8r 21:06:32 01/16/14 Re: Mass produced timing cover? - Bigwill837 21:09:18 01/16/14 Re: Mass produced timing cover? - Bad Fish 21:13:33 01/16/14 Re: Re: Mass produced timing cover? - Bad Fish 21:24:18 01/16/14 Re: Mass produced timing cover? - Stealth_Z 21:57:48 01/16/14 *ding ding ding* ~~winner!~~ (n/m) - 280ZuL8r 07:40:07 01/17/14 Re: Re: Mass produced timing cover? - JaeTee 12:38:11 01/17/14 I'm breaking out my pruning shears and fabbing up more of - LJZTT 21:59:21 01/16/14 Haha that was a good one ^ (n/m) - Krazyd27(Houston) 10:48:18 01/17/14 what about with cut outs so you can still adjust the cams (n/m) - z32Indy 11:58:50 01/17/14 easier said than done - LJZTT 13:51:36 01/17/14 Agreed. My OEM plastics exploded into millions of shards. (n/m) - 280ZuL8r 15:02:51 01/17/14 I tried too. Just couldn't find a clean way of cutting them - Evan_Wright (Ca) 15:20:47 01/17/14 I am thinking there is a real market for some aftermarket - LJZTT 15:41:20 01/17/14 Would it be the end of the world if you still had to drain - black300zx 17:01:52 01/17/14 I have probably drained/filled my coolant more times in the - LJZTT 17:30:17 01/17/14 It is possible to modify the cover so it can be removed - xpwarrior 20:47:24 01/17/14 That looks terrible in practice and defeats the point of - Bernie (NoVA) 11:05:45 01/18/14 Mine looks like normal when installed on the engine and - xpwarrior 21:21:25 01/18/14
Post a Followup	You cannot reply to this message because you are not logged in.