Subject	Re: Mass produced timing cover?
Posted by	Bigwill837 on January 16, 2014 at 9:09 PM
	This message has been viewed 196 times.
In Reply To	Mass produced timing cover? posted by 280ZuL8r on January 16, 2014 at 08:58 PM
Message	There are no timing covers on the Z in your picture. There is a powder-coated (gray) rear timing plate, but that's OEM. That was certainly mass produced. Does this answer your question? Or were you looking at something else?
Follow Ups	Mass produced timing cover? - 280ZuL8r 20:58:40 01/16/14 I see no timing cover here (n/m) - Zvil (FL) 21:00:29 01/16/14 Covering top of cam gears and belt, Yolo? - 280ZuL8r 21:06:32 01/16/14 Re: Mass produced timing cover? - Bigwill837 21:09:18 01/16/14 Re: Mass produced timing cover? - Bad Fish 21:13:33 01/16/14 Re: Re: Mass produced timing cover? - Bad Fish 21:24:18 01/16/14 Re: Mass produced timing cover? - Stealth_Z 21:57:48 01/16/14 *ding ding ding* ~~winner!~~ (n/m) - 280ZuL8r 07:40:07 01/17/14 Re: Re: Mass produced timing cover? - JaeTee 12:38:11 01/17/14 I'm breaking out my pruning shears and fabbing up more of - LJZTT 21:59:21 01/16/14 Haha that was a good one ^ (n/m) - Krazyd27(Houston) 10:48:18 01/17/14 what about with cut outs so you can still adjust the cams (n/m) - z32Indy 11:58:50 01/17/14 easier said than done - LJZTT 13:51:36 01/17/14 Agreed. My OEM plastics exploded into millions of shards. (n/m) - 280ZuL8r 15:02:51 01/17/14 I tried too. Just couldn't find a clean way of cutting them - Evan_Wright (Ca) 15:20:47 01/17/14 I am thinking there is a real market for some aftermarket - LJZTT 15:41:20 01/17/14 Would it be the end of the world if you still had to drain - black300zx 17:01:52 01/17/14 I have probably drained/filled my coolant more times in the - LJZTT 17:30:17 01/17/14 It is possible to modify the cover so it can be removed - xpwarrior 20:47:24 01/17/14 That looks terrible in practice and defeats the point of - Bernie (NoVA) 11:05:45 01/18/14 Mine looks like normal when installed on the engine and - xpwarrior 21:21:25 01/18/14
Post a Followup	You cannot reply to this message because you are not logged in.