Subject	follow-up on whiteline subframe bushing issue
Posted by	aliaZ on January 04, 2014 at 4:00 PM
	This message has been viewed 765 times.
Message	[ http://www.twinturbo.net/nissan/300zx/forums/general/view/2563151/Pics---bushing-center-measurements.html ] I measured my Nismo subframe bushings, and they measure the same as the whiteline 92446. However, I installed them long ago, and forgot that I included an extra spacer in the front bushings as follows: I don't remember if the installation instructions said to do this, or if the kit came with the extra cups from the rear mount to use under the front brackets as spacers. Bottom line is the whiteline 92446 bushings appear to be correct.
Follow Ups	follow-up on whiteline subframe bushing issue - aliaZ 16:00:34 01/04/14 The Nismo bushings you installed are for S14. - Bernie (NoVA) 18:20:29 01/04/14 I didn't install S14 subframe bushings - aliaZ 03:18:40 01/05/14 Well they are also too short and required a spacer ... - ConVerTT 09:33:48 01/05/14 not sure what to tell you - aliaZ 14:41:15 01/05/14 Hopefully I will be able to agree re: best option ... - ConVerTT 09:46:31 01/06/14 Then what you likely have is R32/R33 bushings. (n/m) - Bernie (NoVA) 23:40:36 01/05/14 Example - Bernie (NoVA) 23:44:38 01/05/14 nope...that isn't it either - aliaZ 07:48:40 01/06/14 Bottom line is the 92446 is 10 mm too short and will require - ConVerTT 21:39:23 01/04/14 Bottom line is the 92446 will work but the 92447 won't - aliaZ 03:22:49 01/05/14 About the 447s.... - ConVerTT 09:03:44 01/05/14 just adding another data point - aliaZ 14:30:06 01/05/14 I agree with this and it's exactly what I had to do. (n/m) - Boosted1 07:48:04 01/05/14
Post a Followup	You cannot reply to this message because you are not logged in.