Subject	Flush fender 18" wheel set up
Posted by	JMartz on December 31, 2013 at 8:02 PM
	This message has been viewed 234 times.
In Reply To	Re: need flush fender 18" wheel set up posted by z-owned on December 31, 2013 at 03:30 PM
Message	Flush in the rear, a bit insie in the front, or else there will be insufficient clerance at bump-stop travel with steering at lock. 18 x 8.5 +35 (245/40) and 18 x 9.5 +45 (275/35) Wider wheels are possible, 9 front and 10 rear. You can calculate those offsets from the info above. e.g., 10 inch wheels are 12.7mm wider, 6.35 to each side from center. Remove the 6.35 from the offset to get the wheel/tire inward that much. The 10 incher would need an offset of 51 or 52. Tire size would have to be bigger 285 or so.
Follow Ups	need flush fender 18" wheel set up - ConverTTZ 13:04:13 12/31/13 I run 20 offset in the front on 19x8 and 35 offset in the - CmyZ 13:21:22 12/31/13 there is practically nothing to roll on the front fenders - LJZTT 13:39:52 12/31/13 I'd try spacers to find the offset that's drivable (n/m) - 280ZuL8r 15:12:08 12/31/13 Re: need flush fender 18" wheel set up - z-owned 15:30:04 12/31/13 Basically, I kinda eyeball estimated that it would take 3/4" - ConverTTZ 15:51:46 12/31/13 Flush fender 18" wheel set up - JMartz 20:02:22 12/31/13 I'll be mounting some F-19x9.5 +17 R-19x10.5 + 24. I'll - TTZ2NV(EPTmotorsports) 21:34:54 12/31/13
Post a Followup	You cannot reply to this message because you are not logged in.