| A good time to refresh, upgrade and try some new things out. 1. New front uprights with new kingpin bearings, new kingpins and seals 2. New lug studs for all 4 corners 3. New front and rear wheel bearings and seals 4. New bearings for my SPL titanium tension rods and V5 tie rods ends (the ones that came with them made a lot of noise...they sent me the new version bearings) 5. Driftworks lower control arms with roll center adjustment 6. Powertrix V2 front lower coilover cups 7. Swift springs from Powertrix 7kg/mm and 5kg/mm 8. Powertrix SS coilover upper mounts 9. New 02 sensors 10. New temp sensor 11. Not pictured is some new stainless steel brake lines and motul fluid for a drain and bleed. Got a lot of work ahead of me! Hoping the swift springs and SS upper mounts make the ride just a tad bit softer (getting really close to the perfect balance of performance and comfort). Also, my lower control arms and ball joints are still in there from the factory and are starting to get loose; the driftworks LCAs should cover that and dial the roll center back close to factory spec with the 1.25" drop. 
|
Winter project: Refresh, Upgrade and Trial - 
17:55:29 12/06/13
