Subject	I thought the turbo was balanced as an assembly?
Posted by	aliaZ on December 03, 2013 at 4:11 PM
	This message has been viewed 215 times.
In Reply To	I suppose its all in your comfortability posted by BOOZTD 3 on December 03, 2013 at 03:38 PM
Message	if that is the case, you'd still have to balance the turbo no matter if the new compressor wheel is already balanced
Follow Ups	Opinions on a Nicked Compressor Wheel - TyTyIsFly27 23:04:28 12/02/13 I wouldnt trust that. (n/m) - michaell32 (FL) 00:22:07 12/03/13 What happened? Did it eat something? (n/m) - hunterg 00:36:16 12/03/13 out of balance - Zvil (FL) 06:58:54 12/03/13 Replace. (n/m) - njz 07:21:46 12/03/13 I would definitely avoid that. - The Hawk 10:39:21 12/03/13 Second cause for concern: what other impact damage came - zellamay 12:22:23 12/03/13 Someone probably dropped a bolt/nut into the turbo inlet... (n/m) - BOOZTD 3 15:49:04 12/03/13 Thanks Everyone - TyTyIsFly27 13:06:32 12/03/13 Its a garret part right....? - BOOZTD 3 15:08:30 12/03/13 Why not just get a new CHRA for $400 and you'll have - ZXoltan 15:12:47 12/03/13 I suppose its all in your comfortability - BOOZTD 3 15:38:48 12/03/13 I thought the turbo was balanced as an assembly? - aliaZ 16:11:19 12/03/13 Depends on the turbo - -Grimm- 17:05:03 12/03/13 they could remove material from the wheel just as easily - aliaZ 17:27:13 12/03/13 Lots balance the wheel - BOOZTD 3 17:37:28 12/03/13 Re: Lots balance the wheel - TyTyIsFly27 22:38:41 12/03/13 that is my understanding as well - aliaZ 23:09:40 12/03/13 i know you can probably change a turbo in an afternoon... - Antihero 19:50:48 12/03/13 2nd. Logical advice (n/m) - ConVerTT 20:33:48 12/03/13 My thoughts exactly. - TyTyIsFly27 22:29:26 12/03/13 A CHRA for this turbo runs almost 1k - TyTyIsFly27 22:32:48 12/03/13 Thought it was a stocker. I would pass - ZXoltan 02:44:41 12/04/13 Just replace the center section, as advised. Then it will - CmyZ 15:57:21 12/03/13 Call Turbosdirect for the Garrett CHRA exchange program - Doug71zt(CAN) 13:36:52 12/04/13
Post a Followup	You cannot reply to this message because you are not logged in.