Subject	It's essentially a potentiometer that adjusts an offset
Posted by	ztunerz on November 25, 2013 at 9:15 PM
	This message has been viewed 279 times.
In Reply To	Which have you used with success? (n/m) posted by KongZTT GT28RS MD on November 25, 2013 at 02:34 PM
Message	Table controlling boost. I think standalone boost control allows boost by speed (gear) , can be indexed to fuel, ait, oil temp or any other parameter you want. I see no reason to "turn down boost" if you factor in all the parameters listed above. Standalone boost control has the potential to be far superior to traditional ebc's. A lot of tuners can't deal with it because they do not understand PID controllers and how to go about tuning it. Most customers do not realize that standalone a are a blank slate and its up to you to take full advantage of all the features . Typical question is "how much power will it make over alternate solutions" In the end stand alones have more to do with refinement and control than outright power. Harry Formerly yellowzxtt
Follow Ups	Anyone use self tune feature on their Haltech? - KongZTT GT28RS MD 09:25:09 11/25/13 IIRC...it's called Target 02 tuning, or adaptive strategy on - TTZ2NV(EPTmotorsports) 10:47:36 11/25/13 I remember kuah @spl having two solenoids on his motec - KongZTT GT28RS MD 11:13:34 11/25/13 Intimate=ultimate I meant (n/m) - KongZTT GT28RS MD 11:37:32 11/25/13 you snuggle with electronics, don't lie (n/m) - LJZTT 12:26:19 11/25/13 ...... - KongZTT GT28RS MD 14:33:20 11/25/13 TMI (n/m) - LJZTT 18:31:00 11/25/13 Btw the black oem rings fixed the leakage issue that - ztunerz 21:18:59 11/25/13 I was under the impression they were designed to swell to - KongZTT GT28RS MD 21:25:22 11/25/13 2nd. Harry, are you using r134a or r12? - bartz32tt 12:00:57 11/26/13 134. I too thought that the green rings were the correct - ztunerz 18:47:11 11/26/13 they work fine with POE (n/m) - aliaZ 22:32:27 11/26/13 Boost trim knob (n/m) - ztunerz 12:46:26 11/25/13 Which have you used with success? (n/m) - KongZTT GT28RS MD 14:34:07 11/25/13 It's essentially a potentiometer that adjusts an offset - ztunerz 21:15:07 11/25/13 I don't use built-in boost control - sparkie 11:44:23 11/27/13 You can also use GM part #13577379. This has a little - not4resaleZ 12:00:28 11/25/13 If you have the calibration table you can use ANY sensor - ztunerz 21:16:37 11/25/13 Many of the newer vehicles/ECUs - BOOZTD 3 15:39:28 11/25/13 Re: Anyone use self tune feature on their Haltech? - ztunerz 12:45:20 11/25/13 I have also noticed - BOOZTD 3 15:38:14 11/25/13 You can turn down the range and response time in - ztunerz 21:06:23 11/25/13 Re: Anyone use self tune feature on their Haltech? - sparkie 19:28:06 11/25/13 I guess I'll hold into my dual solenoid blitz controller.. - KongZTT GT28RS MD 21:22:47 11/25/13 Re: I guess I'll hold into my dual solenoid blitz controller.. - sparkie 23:44:40 11/26/13
Post a Followup	You cannot reply to this message because you are not logged in.