Subject	AIV and EGR solenoid questions:
Posted by	doug8867 on November 16, 2013 at 12:26 PM
	This message has been viewed 283 times.
Message	I've had my AIVs and EGR removed for a while but have left the solenoids connected, capped and in place. Now I'm getting ready to install a boost controller and wanted to clean up the vacuum lines while I'm at it. If I remove the AIV and EGR solenoids completely and leaving the electrical harness connectors disconnected will that cause any codes or other issues? I've got a chipped Ash-Spec ECU in place that was done before the EGR was removed. Thanks.
Follow Ups	AIV and EGR solenoid questions: - doug8867 12:26:15 11/16/13 No codes, you will be fine (n/m) - itsa300zx 12:41:57 11/16/13 Thanks. (n/m) - doug8867 09:12:38 11/17/13
Post a Followup	You cannot reply to this message because you are not logged in.