Subject	With a relay.
Posted by	fuzzymonkey on November 07, 2013 at 4:11 PM
	This message has been viewed 189 times.
In Reply To	and then how are you going to make the new run switched? posted by Antihero on November 07, 2013 at 12:01 PM
Message	The only thing your radio or ignition wire will do is give the relay the signal to *click* and allow the feed from directly off the battery to flow through to the fuse block. The radio wire is only keeping the relay closed, and uses neglectable power. The direct feed from the battery feeds the accessories. Just because wires and fuses that are placed have "extra room", doesn't necessarily mean you should use up the extra room they have. Leave a working thing as is, and start one fresh for all the EXTRAs you are adding. Even if you do not agree with any of my electrical reasonings, you would undoubtedly agree that it is the cleanest, and easiest to add/remove accessories.
Follow Ups	valentine one install - PYROhafe 07:37:10 11/06/13 Using a fuse tap is easiest, or... - ThisIsSparTTa 08:46:42 11/06/13 "Just tap off a circuit that is on with the car" - The Hawk 09:04:34 11/06/13 I used the fuse for the radio. - AHos(Chicago) 09:48:52 11/06/13 Pretty sure I tapped off of Radio fuse as well. - ThisIsSparTTa 13:21:45 11/06/13 thanks! - PYROhafe 09:48:54 11/06/13 This is how I did it, connected to a switched power supply - ThunderZ 21:30:47 11/06/13 A lot of people tap in the power near the map light - Summeronthechain (MN) 08:47:08 11/06/13 Yea I've seen quite a few tap into the map light (n/m) - Piranha 10:52:53 11/06/13 Map light tap has been fine for about 20 years now. (n/m) - not4resaleZ 12:35:32 11/06/13 Yup, just remember to shut the detector off or it will drain - ZinnZ32 16:10:28 11/06/13 Taped into fuse in driver’s kick panel. - SilverZXTT(CO) 14:53:52 11/06/13 do it once, do it right - fuzzymonkey 15:55:25 11/06/13 This is beyond overkill... - ThisIsSparTTa 08:47:52 11/07/13 No it's not at all actually... - ttsmokin 10:23:45 11/07/13 It is beyond overkill because the current draw for the radar - MixManMash 11:12:01 11/07/13 Agreed, using an add-a-circuit with a fuse equal to the - BigTDogg (MA) 11:24:28 11/07/13 Again, do it once, do it right. - fuzzymonkey 16:01:22 11/07/13 I disagree. - Antihero 16:08:42 11/07/13 see my reply "With a relay" below. (n/m) - fuzzymonkey 16:13:33 11/07/13 lol. Go ahead, argue with an electrical engineer. - MixManMash 16:34:33 11/07/13 Basic electrical engineering knowledge disagrees with you - ThisIsSparTTa 14:54:10 11/07/13 and then how are you going to make the new run switched? - Antihero 12:01:17 11/07/13 With a relay. - fuzzymonkey 16:11:14 11/07/13 I still disagree with the unnecesary home run. - Antihero 08:38:19 11/08/13 THIS... - 240Z FeO2 23:14:21 11/06/13 I have no idea whether this is relevant, or helps, but I'll - zellamay 23:41:08 11/06/13 HA! great - you can drive in front of me! (n/m) - SuparexTT 14:05:53 11/07/13
Post a Followup	You cannot reply to this message because you are not logged in.