Subject	I would not do what this guy did:
Posted by	not4resaleZ on November 01, 2013 at 10:27 AM
	This message has been viewed 287 times.
In Reply To	Since tomorro will be the day after Halloween fog machines posted by z32z on October 31, 2013 at 08:34 AM
Message	[ http://www.garagejournal.com/forum/showthread.php?t=91216&page=9 ] Photo near the bottom of the page. The little fog machine "boiler" has to try to heat up the entire mess of fittings and if you run air from the compressor thru it, it's even worse. Probably get a lot of water out of it. When I built mine, I tried to thermally isolate the compressor fitting section from the fog machine.
Follow Ups	Since tomorro will be the day after Halloween fog machines - z32z 08:34:21 10/31/13 Here's a link that discusses a home built one - spicyZ 08:50:01 10/31/13 I tried making one, however it wasn't a success. I couldn't - Attridge_300ZX 09:00:34 10/31/13 Would you make a fitting like a boost leak tester and - z32z 09:14:36 10/31/13 Yes I use the same adapter with a quick connect fitting. (n/m) - Attridge_300ZX 09:19:20 10/31/13 Could be done in parts - -Grimm- 09:28:27 10/31/13 Worked good for me. Easy to make. (n/m) - Woody75 (Denver) 09:12:15 10/31/13 I have been only able to locate exhaust leaks with mine but - SMAZ (OKC) 09:30:40 10/31/13 I am looking more for boost leaks rather then exhaust leaks. (n/m) - z32z 09:36:45 10/31/13 I didn't realize there were different types of fog juice, I - Attridge_300ZX 09:41:25 10/31/13 I used the stuff that came with the machine. (n/m) - Woody75 (Denver) 11:28:48 10/31/13 some juices use sugar so watch out. - inf 19:29:30 10/31/13 I tried making one, and it didn't work worth a damn - aliaZ 07:11:44 11/01/13 I would not do what this guy did: - not4resaleZ 10:27:10 11/01/13
Post a Followup	You cannot reply to this message because you are not logged in.