Subject	I think splines are designed and sized...
Posted by	-Grimm- on October 31, 2013 at 2:06 PM
	This message has been viewed 198 times.
In Reply To	About 1 5/8" still out, also I'm realizing some of the trans posted by Jkova300z on October 31, 2013 at 10:55 AM
Message	... for output and load conditions. I don't think leaving that much spline disengaged is a good idea.
Follow Ups	How much slack should the Z1 platinum driveshaft have? - Jkova300z 09:38:11 10/30/13 2" seems excessive - -Grimm- 09:58:20 10/30/13 Dimensions: - Jkova300z 10:13:04 10/30/13 I'm not in the shop right now - -Grimm- 11:14:16 10/30/13 Here are two pictures of what I'm talking about: - Jkova300z 10:04:00 10/30/13 You are missing the rear dust cover on the trans. - ztunerz 10:22:39 10/30/13 Never mind I just saw pic 2. It is a bit much after you - ztunerz 10:24:26 10/30/13 Does anyone else have a platinum shaft the can measure or - Jkova300z 12:15:36 10/30/13 Take a look @ it when the car is one the ground (n/m) - Bernie (NoVA) 01:11:20 10/31/13 About 1 5/8" still out, also I'm realizing some of the trans - Jkova300z 10:55:47 10/31/13 I think splines are designed and sized... - -Grimm- 14:06:34 10/31/13 There must be others with the platinum driveshaft on here, - Jkova300z 16:36:23 10/31/13 Have you contacted Z1 about their product yet? - Bernie (NoVA) 21:13:32 10/31/13 Yea I did before I posted. - Jkova300z 21:42:42 10/31/13 Any driveshaft will have some slack otherwise they would - Bernie (NoVA) 08:21:50 11/01/13
Post a Followup	You cannot reply to this message because you are not logged in.