Subject	Does anyone else have a platinum shaft the can measure or
Posted by	Jkova300z on October 30, 2013 at 12:15 PM
	This message has been viewed 220 times.
In Reply To	Never mind I just saw pic 2. It is a bit much after you posted by ztunerz on October 30, 2013 at 10:24 AM
Message	Look at how it mates to the trans? I just installed the diff side completely and I have exactly 2" of The splined yoke sticking out in the pic. So that will leave around 2" of it still inside the trans. Not sure if that's sufficient.
Follow Ups	How much slack should the Z1 platinum driveshaft have? - Jkova300z 09:38:11 10/30/13 2" seems excessive - -Grimm- 09:58:20 10/30/13 Dimensions: - Jkova300z 10:13:04 10/30/13 I'm not in the shop right now - -Grimm- 11:14:16 10/30/13 Here are two pictures of what I'm talking about: - Jkova300z 10:04:00 10/30/13 You are missing the rear dust cover on the trans. - ztunerz 10:22:39 10/30/13 Never mind I just saw pic 2. It is a bit much after you - ztunerz 10:24:26 10/30/13 Does anyone else have a platinum shaft the can measure or - Jkova300z 12:15:36 10/30/13 Take a look @ it when the car is one the ground (n/m) - Bernie (NoVA) 01:11:20 10/31/13 About 1 5/8" still out, also I'm realizing some of the trans - Jkova300z 10:55:47 10/31/13 I think splines are designed and sized... - -Grimm- 14:06:34 10/31/13 There must be others with the platinum driveshaft on here, - Jkova300z 16:36:23 10/31/13 Have you contacted Z1 about their product yet? - Bernie (NoVA) 21:13:32 10/31/13 Yea I did before I posted. - Jkova300z 21:42:42 10/31/13 Any driveshaft will have some slack otherwise they would - Bernie (NoVA) 08:21:50 11/01/13
Post a Followup	You cannot reply to this message because you are not logged in.