Subject	Oversize bore or thickness?
Posted by	ZXoltan on October 28, 2013 at 1:12 PM
	This message has been viewed 143 times.
In Reply To	I can't find oversized OEM gaskets posted by -Grimm- on October 28, 2013 at 12:38 PM
Message	Are you trying to correct timing geometry due to decking the block or heads? If so, you might consider adjustable cam gears instead.
Follow Ups	MLS Gasket vs Head Shims - -Grimm- 20:25:57 10/27/13 Mitch@EP just posted that he was working on a write-up (n/m) - 280ZuL8R 20:41:04 10/27/13 Your decks need to have a minimum RA of 50. If you don't do - TTZ2NV(EPTmotorsports) 02:19:10 10/28/13 Searching for HKS head gaskets... - -Grimm- 09:15:05 10/28/13 That Tomei that mitch mentioned above Is IMO the bees knees - TTZ2NV(EPTmotorsports) 11:27:35 10/28/13 If I recall correctly with the copper gaskets you have to - TTZ2NV(EPTmotorsports) 11:29:51 10/28/13 I read that also (about the O-rings mentioned below) - -Grimm- 11:52:51 10/28/13 So considering my block was not decked (less than 0.0015... - -Grimm- 14:47:31 10/28/13 Why not a stock headgasket? - MixManMash 12:26:10 10/28/13 I can't find oversized OEM gaskets - -Grimm- 12:38:39 10/28/13 Oversize bore or thickness? - ZXoltan 13:12:57 10/28/13 Another option - Antihero 15:26:54 10/28/13
Post a Followup	You cannot reply to this message because you are not logged in.