Subject	Heater Blend Motor, Recirc Motor and Heater Core Valve motor
Posted by	Rasta420 on October 21, 2013 at 8:51 AM
	This message has been viewed 298 times.
Message	So what does everyone do if the motor dies? I have two out of three dead only the recirc motor works, I have verified the little electrical motor is dead, the PCB board looks to be in good shape and the plastic gears are in good shape. Is there a replacement motor I can solder into this to salvage mine or am I doomed to buying off ebay and praying I never have to do this again? Rasta420
Follow Ups	Heater Blend Motor, Recirc Motor and Heater Core Valve motor - Rasta420 08:51:24 10/21/13 Send me a pic, I may have a couple sitting around. (n/m) - ILoveBoost 09:55:30 10/21/13 Re: Heater Blend Motor, Recirc Motor and Heater Core Valve motor - OleMissFan 13:09:03 10/21/13 Re: Re: Heater Blend Motor, Recirc Motor and Heater Core Valve motor - Rasta420 13:26:56 10/21/13 I'm not sure if it is the same on 91z but on my 90Z TT - YlwPrlZTT 17:01:11 10/21/13 Re: I'm not sure if it is the same on 91z but on my 90Z TT - Rasta420 18:07:59 10/21/13 Seems like something DVDBURN would do... (n/m) - Luminar 18:22:08 10/21/13 Re: Seems like something DVDBURN would do... - Rasta420 04:34:05 10/22/13 Post a picture of the drive motor (n/m) - -Grimm- 09:08:55 10/22/13 Re: Post a picture of the drive motor - Rasta420 09:30:25 10/22/13
Post a Followup	You cannot reply to this message because you are not logged in.