TwinTurbo.NET: Nissan 300ZX forum - Build complete[finally]. How much HP you guys think?
People Seeking Info
 
   


     
Subject Build complete[finally]. How much HP you guys think?
     
Posted by kourt11412 on October 18, 2013 at 5:19 PM
  This message has been viewed 1025 times.
     
     
Message So my engine build is finally finish. Not sure how many rwhp I can pull. Currently at 15psi boost, since water/meth not connected. Goal is 500wph.

Short Block (Stage 2) 
Oversize Wiseco forged pistons with new rings
Block bored and honed to proper piston to wall clearance 0.040
Nissan rod and main bearings ARP Studs
Nissan Connecting Rods with ARP bolts
Z1 TT Heads (Stage 2)
Z1 HL-14 cam set 270 deg duration .365 lift
Z1 Performance valve springs
New Viton valve stem seals
High flow radius cut performance valve job Stillen Sidemount Intercoolers
HKS SSQV4 Blow Off Valve Kit (BOV)
Nismo Thermostat
Mega Z Air Guides
Setrab 19 Row TT Oil Cooler Upgrade
Koyo Z32TT Aluminum Racing Radiator
Apexi 401-A917 AFC Neo Fuel Management
RPS Twinturbo MAX Street Clutch
Apexi multichecker*
Selin Dual MAF Translator
JWT Dual Pop Intake
Greddy Profec B SPEC2 Boost Controller 
PLX M-300 Wideband O2 Sensor w/ Controller* 
BDE Performance Exhaust Cam Plugs
NGK Iridium Spark Plugs-NGK PFR6B-11B
New EFI Wiring Harness  
JWT HD VTC Springs
AMS Max Flow TT Exhaust Manifolds
Turbos GT28RS-Disco Potato-.86
HKS Hiper Cat-back Exhaust System
5 bolt downpipes
Nissan Fuel Rail Kit (new style)
Sard 850cc Fuel Injector
Snow Performance Stage 3 Boost Water/Meth Injection*
Z32 Front Strut Tower Brace*
Powdercoated Upper Intake Plenum
Powdercoated VG30DE(TT) Valve Covers
Powdercoated Water Pipes w/ NEW OEM Water Pipes
Powdercoated Balance Tube
Powdercoated-Crank Angle holder

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.