Subject	This is the best way. 5 gal bucket o' water. 90psi
Posted by	ZinnZ32 on October 10, 2013 at 1:15 PM
	This message has been viewed 218 times.
In Reply To	we just used 2 small chunks of fuel line on my SZ setup posted by vorpalZ on October 10, 2013 at 01:00 PM
Message	This way you can be damn sure your O-Rings don't leak! __________ Version 3.01
Follow Ups	Fuel pressure tester for 300degree rails and SZ fuel lines - Jkova300z 11:59:24 10/10/13 we just used 2 small chunks of fuel line on my SZ setup - vorpalZ 13:00:25 10/10/13 This is the best way. 5 gal bucket o' water. 90psi - ZinnZ32 13:15:55 10/10/13 Any danger of corroding the injectors from water immersion? (n/m) - ZXoltan 16:42:32 10/10/13 The water doesn't go inside them... That's where the air is. - ZinnZ32 16:57:33 10/10/13 why not just turn the pump on with the rail off the engine? (n/m) - LJZTT 17:52:40 10/10/13 Because boost (n/m) - Evan_Wright (Ca) 19:12:37 10/10/13 FWIW - a few years back I used a air hand pump with - jzack 18:43:05 10/10/13
Post a Followup	You cannot reply to this message because you are not logged in.