Subject	Fuel pressure tester for 300degree rails and SZ fuel lines
Posted by	Jkova300z on October 10, 2013 at 11:59 AM
	This message has been viewed 382 times.
Message	I've seen some write ups on doing this with setups guys made themselves. Is there any off the sheld fuel pressure testing kits that work well. I found that a local autozone has this one I can rent which might work: Auto Zone fp tester Looks like I can just connect the SZ hoses up to the T-juntion with the scharder valve and pressurize it; then submerge and look for leaks.
Follow Ups	Fuel pressure tester for 300degree rails and SZ fuel lines - Jkova300z 11:59:24 10/10/13 we just used 2 small chunks of fuel line on my SZ setup - vorpalZ 13:00:25 10/10/13 This is the best way. 5 gal bucket o' water. 90psi - ZinnZ32 13:15:55 10/10/13 Any danger of corroding the injectors from water immersion? (n/m) - ZXoltan 16:42:32 10/10/13 The water doesn't go inside them... That's where the air is. - ZinnZ32 16:57:33 10/10/13 why not just turn the pump on with the rail off the engine? (n/m) - LJZTT 17:52:40 10/10/13 Because boost (n/m) - Evan_Wright (Ca) 19:12:37 10/10/13 FWIW - a few years back I used a air hand pump with - jzack 18:43:05 10/10/13
Post a Followup	You cannot reply to this message because you are not logged in.