Subject	Good info thanks (n/m)
Posted by	Jkova300z on October 07, 2013 at 12:33 PM
	This message has been viewed 153 times.
In Reply To	Best way to clean manifold after porting? posted by Jkova300z on October 07, 2013 at 09:24 AM
Message
Follow Ups	Best way to clean manifold after porting? - Jkova300z 09:24:55 10/07/13 WD 40 works pretty good for me, then just rinse with water - Zvil (FL) 09:41:29 10/07/13 Some Dawn and water, soak in a large tub. Let it sit for - CmyZ 09:51:26 10/07/13 I used a shop vac with a small enough hose to fit deep into - JUNz (?00)rwhp 10:38:46 10/07/13 Re: Some Dawn and water, soak in a large tub. Let it sit for - Zsgetyoulaid 11:20:35 10/07/13 Re: Re: Some Dawn and water, soak in a large tub. Let it sit for - wild_maxx 11:29:02 10/07/13 Home Depot, drier vent brush. Very long and perfect size. (n/m) - Woody75 (Denver) 12:55:10 10/07/13 bag would probably be easier than tub for most... (n/m) - Antihero 20:06:20 10/07/13 Pressure washer. (n/m) - xpwarrior 11:41:44 10/07/13 Good info thanks (n/m) - Jkova300z 12:33:07 10/07/13
Post a Followup	You cannot reply to this message because you are not logged in.