Subject	Some Dawn and water, soak in a large tub. Let it sit for
Posted by	CmyZ on October 07, 2013 at 9:51 AM
	This message has been viewed 169 times.
In Reply To	WD 40 works pretty good for me, then just rinse with water posted by Zvil (FL) on October 07, 2013 at 09:41 AM
Message	a bit, if you have some long brushes, scrub the inside, then rinse and blow dry. That is what I do. since its powder coated you should have no problem.
Follow Ups	Best way to clean manifold after porting? - Jkova300z 09:24:55 10/07/13 WD 40 works pretty good for me, then just rinse with water - Zvil (FL) 09:41:29 10/07/13 Some Dawn and water, soak in a large tub. Let it sit for - CmyZ 09:51:26 10/07/13 I used a shop vac with a small enough hose to fit deep into - JUNz (?00)rwhp 10:38:46 10/07/13 Re: Some Dawn and water, soak in a large tub. Let it sit for - Zsgetyoulaid 11:20:35 10/07/13 Re: Re: Some Dawn and water, soak in a large tub. Let it sit for - wild_maxx 11:29:02 10/07/13 Home Depot, drier vent brush. Very long and perfect size. (n/m) - Woody75 (Denver) 12:55:10 10/07/13 bag would probably be easier than tub for most... (n/m) - Antihero 20:06:20 10/07/13 Pressure washer. (n/m) - xpwarrior 11:41:44 10/07/13 Good info thanks (n/m) - Jkova300z 12:33:07 10/07/13
Post a Followup	You cannot reply to this message because you are not logged in.