Subject	Best way to clean manifold after porting?
Posted by	Jkova300z on October 07, 2013 at 9:24 AM
	This message has been viewed 216 times.
Message	So I ported my intake manifold for the 60mm TB's. Kept most of the debris out, but have some stuck to the oil film inside. The plenum is powdercoated and my powdercoat guy recomends NOT using a parts washer due to the staining that may occur. Just wanted to see what anyone else does, since theres some tight spots. My only thought was brake clean with the straw followed by washing with water after.
Follow Ups	Best way to clean manifold after porting? - Jkova300z 09:24:55 10/07/13 WD 40 works pretty good for me, then just rinse with water - Zvil (FL) 09:41:29 10/07/13 Some Dawn and water, soak in a large tub. Let it sit for - CmyZ 09:51:26 10/07/13 I used a shop vac with a small enough hose to fit deep into - JUNz (?00)rwhp 10:38:46 10/07/13 Re: Some Dawn and water, soak in a large tub. Let it sit for - Zsgetyoulaid 11:20:35 10/07/13 Re: Re: Some Dawn and water, soak in a large tub. Let it sit for - wild_maxx 11:29:02 10/07/13 Home Depot, drier vent brush. Very long and perfect size. (n/m) - Woody75 (Denver) 12:55:10 10/07/13 bag would probably be easier than tub for most... (n/m) - Antihero 20:06:20 10/07/13 Pressure washer. (n/m) - xpwarrior 11:41:44 10/07/13 Good info thanks (n/m) - Jkova300z 12:33:07 10/07/13
Post a Followup	You cannot reply to this message because you are not logged in.