Subject	turbo compressor outlet flange bolt question
Posted by	vorpalZ on October 04, 2013 at 3:04 PM
	This message has been viewed 416 times.
Message	Hey all, Finally sourced a set of turbo compressor outlet flanges, but the pinheads that removed them from the junk motor didn't save me the bolts to install into my engine. Anybody know the size, length and thread pitch of the mounting bolts? Three are identical on one side, two long ones and a shorty on the drivers side. Thanks, MY Zs ARE HYBRID VEHICLES, THEY RUN ON GASOLINE AND MONEY "I expressed no attitude, I'm correcting you. If you don't like it, try not to be wrong next time. Now you're getting attitude, and if you don't like that you should grow a thicker skin.” - TriniTT 14:04:16 12/22/12 ”Exhaust doesn't produce horsepower” - VERTTZ 13:17:22 06/26/12 I'm off to wax mine and go for a drive now. - BigTDogg (MA) 07:17:08 07/17/09 times change, people change, but the Z32 still kicks ass. - apudapus 16:46:02 06/15/07 I was more wondering how you set your climate control to 22* lol, it would be that fastest freezer on wheels! - Briscoe'sZ32 (NJ) 23:15:44 02/05/07 You have *got* to be getting a cut from B&B :D - SeedyROM 15:24:29 08/16/06 What do you think B&B stands for? - YugoBernie (NoVA) 15:57:09 08/16/06
Follow Ups	turbo compressor outlet flange bolt question - vorpalZ 15:04:03 10/04/13 M6 x 1.0 thread and pitch. Length 3 x 25MM P/S. - CmyZ 15:45:02 10/04/13 Perfect... thx. (n/m) - vorpalZ 15:56:08 10/04/13
Post a Followup	You cannot reply to this message because you are not logged in.