Subject	I used VHT header paint
Posted by	BlackholeZ on October 03, 2013 at 12:34 PM
	This message has been viewed 229 times.
In Reply To	Solutions for rust ring with 350Z track rotors? posted by Jayru on October 03, 2013 at 09:55 AM
Message	Painted the rotors inside and out and didn't worry about masking the braking surface. Went out and bedded the brakes and cured the paint. So far it is holding up well, no rust, and it also keeps it from rusting to the hub or wheel. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Solutions for rust ring with 350Z track rotors? - Jayru 09:55:44 10/03/13 I do not have that brake setup but here is what I do: - TT-Z (Cape Coral, FL) 11:22:46 10/03/13 I would not recommend this method - ttsmokin 11:39:12 10/03/13 word. oil + rotor = wtf? (n/m) - shaggee 12:12:07 10/03/13 WD-40 isn't an oil though.. Its mostly Kerosene.. - Ash's Z 15:18:22 10/03/13 I hope this is a troll post. (n/m) - Antihero 14:25:53 10/03/13 LOL. Na man just a little wd40 and your good to go! (n/m) - VERTTZ 15:01:08 10/03/13 I used VHT header paint - BlackholeZ 12:34:24 10/03/13 Thanks everyone - Jayru 12:37:36 10/03/13 You painted the whole rotor? - ZXRider 12:39:29 10/03/13 It's really a minimal layer that gets removed very quickly. - BlackholeZ 15:50:16 10/03/13 buy zinc plated rotors to start with is the easiest way. (n/m) - Antihero 14:27:07 10/03/13 Completely missing the mark here - Jayru 14:44:14 10/03/13 plated rotors are usually 100% plated. - Antihero 14:50:43 10/03/13 this is true (n/m) - ForceFedTT (SoCal) 15:18:31 10/03/13 Hmm, my rotors were Chryo treated - Jayru 15:39:14 10/03/13 If the entire rotor is zinc plated to start, only the rotor - boileralum 14:51:05 10/03/13 This is the ideal solution. - BlackholeZ 15:51:37 10/03/13 I used an industrial grade high temp stainless steel coat - VERTTZ 14:58:41 10/03/13 Source? I've never heard of such a thing. (n/m) - BigTDogg (MA) 20:55:58 10/03/13
Post a Followup	You cannot reply to this message because you are not logged in.