Subject	Although I didn't have uneven alignment problems,
Posted by	scoops on October 03, 2013 at 11:58 AM
	This message has been viewed 224 times.
In Reply To	What's the magic trick to line up the exhaust? posted by ZXRider on October 03, 2013 at 02:31 AM
Message	it was overly difficult bolting the parts together.After Greg/Seb's inspection, a new transmission mount helped alot with putting it all together. Gave the pipes more adjustability
Follow Ups	What's the magic trick to line up the exhaust? - ZXRider 02:31:48 10/03/13 I bend up or down the rearmost exhaust hangers (n/m) - Drk93TT 08:00:35 10/03/13 Which one are you talking about specifically? - ZXRider 08:06:51 10/03/13 How sure are you that they are SZ Dp's.... - TTZ2NV(EPTmotorsports) 10:14:30 10/03/13 The DPs were purchased from a member - ZXRider 10:32:26 10/03/13 Did you have cats welded in or replace the whole pipe? (n/m) - -Grimm- 14:14:05 10/03/13 Although I didn't have uneven alignment problems, - scoops 11:58:19 10/03/13 How did the mount give more adjustability? - ZXRider 12:19:38 10/03/13 My exhaust sat lower after a new trans mount. The angle - scoops 13:50:35 10/03/13 My solution... - 240Z FeO2 12:09:14 10/03/13 Thanks for the link - ZXRider 12:20:35 10/03/13 Didnt you basically make it a rigid mount set up though? - Woody75 (Denver) 13:48:48 10/03/13 Correct. The rubber muffler hangers, with the addition of - 240Z FeO2 18:46:35 10/03/13
Post a Followup	You cannot reply to this message because you are not logged in.