Subject	How sure are you that they are SZ Dp's....
Posted by	TTZ2NV(EPTmotorsports) on October 03, 2013 at 10:14 AM
	This message has been viewed 211 times.
In Reply To	What's the magic trick to line up the exhaust? posted by ZXRider on October 03, 2013 at 02:31 AM
Message	I've seen certain brands of dp's for our cars that made the exhaust either off center or to hi/low, or too far in or out. You should be able to install the complete exhaust with the bolts loose, start from the front, position the pipes where you want them and tighten the bolts.
Follow Ups	What's the magic trick to line up the exhaust? - ZXRider 02:31:48 10/03/13 I bend up or down the rearmost exhaust hangers (n/m) - Drk93TT 08:00:35 10/03/13 Which one are you talking about specifically? - ZXRider 08:06:51 10/03/13 How sure are you that they are SZ Dp's.... - TTZ2NV(EPTmotorsports) 10:14:30 10/03/13 The DPs were purchased from a member - ZXRider 10:32:26 10/03/13 Did you have cats welded in or replace the whole pipe? (n/m) - -Grimm- 14:14:05 10/03/13 Although I didn't have uneven alignment problems, - scoops 11:58:19 10/03/13 How did the mount give more adjustability? - ZXRider 12:19:38 10/03/13 My exhaust sat lower after a new trans mount. The angle - scoops 13:50:35 10/03/13 My solution... - 240Z FeO2 12:09:14 10/03/13 Thanks for the link - ZXRider 12:20:35 10/03/13 Didnt you basically make it a rigid mount set up though? - Woody75 (Denver) 13:48:48 10/03/13 Correct. The rubber muffler hangers, with the addition of - 240Z FeO2 18:46:35 10/03/13
Post a Followup	You cannot reply to this message because you are not logged in.