Subject	Which one are you talking about specifically?
Posted by	ZXRider on October 03, 2013 at 8:06 AM
	This message has been viewed 190 times.
In Reply To	I bend up or down the rearmost exhaust hangers (n/m) posted by Drk93TT on October 03, 2013 at 08:00 AM
Message	The hangers on/attached to the exhaust or the ones attached to the frame of the car? Also are you talking about the ones right by the exhaust tips? (The ones right above the muffler can that are two side by side and a little difficult to get to). Thanks. Buy Zama Posters Here I have nightmares about that happening...I'd be the poor bastard you'd hear about on the news that gets killed by a softball-size chunk while spreading out my body over the hood and screaming "Nooo!" (Having a conversation about hail damage) - BradZ (FL) on March 25, 2005 at 9:56 PM Tell your friend that you could take a dump, light it on fire and that would be hotter shit than his car. Probes suck, that's just all there is to it. - 300ZXpert (someday) on April 04, 2005 at 11:35 PM P.S. You REALLY are on here at ALL hours! And I thought I was bad! :) - zmenon on August 16, 2005 at 3:06 AM LOL...2+2 drivers should grow mullets..."Business in the front...party in the back" ;) - BradZ (FL) on November 29, 2005 at 4:45 PM
Follow Ups	What's the magic trick to line up the exhaust? - ZXRider 02:31:48 10/03/13 I bend up or down the rearmost exhaust hangers (n/m) - Drk93TT 08:00:35 10/03/13 Which one are you talking about specifically? - ZXRider 08:06:51 10/03/13 How sure are you that they are SZ Dp's.... - TTZ2NV(EPTmotorsports) 10:14:30 10/03/13 The DPs were purchased from a member - ZXRider 10:32:26 10/03/13 Did you have cats welded in or replace the whole pipe? (n/m) - -Grimm- 14:14:05 10/03/13 Although I didn't have uneven alignment problems, - scoops 11:58:19 10/03/13 How did the mount give more adjustability? - ZXRider 12:19:38 10/03/13 My exhaust sat lower after a new trans mount. The angle - scoops 13:50:35 10/03/13 My solution... - 240Z FeO2 12:09:14 10/03/13 Thanks for the link - ZXRider 12:20:35 10/03/13 Didnt you basically make it a rigid mount set up though? - Woody75 (Denver) 13:48:48 10/03/13 Correct. The rubber muffler hangers, with the addition of - 240Z FeO2 18:46:35 10/03/13
Post a Followup	You cannot reply to this message because you are not logged in.