Subject	More factors come into play...
Posted by	Madhatter10-6 on October 01, 2013 at 9:48 AM
	This message has been viewed 648 times.
In Reply To	Walbro 485 max hp on E85? posted by Bumblebeetuna on September 30, 2013 at 11:20 AM
Message	It will depend on: the size of your injectors what your base PSI is set at Volts to the pump What dyno your on With ID 1,000's base PSI of 45 12 volts on a dyno dynamics Two 485's (-8an) You can hit 650 ish 28-30ish PSI The problem with 485 pumps is that they fall on their face at higher RPM's / Pressure Madhatter10-6
Follow Ups	Walbro 485 max hp on E85? - Bumblebeetuna 11:20:40 09/30/13 Not enough with e85. You need 2 pumps and 1300 cc inj - ztunerz 11:26:17 09/30/13 How about gt600's? (n/m) - Bumblebeetuna 13:29:11 09/30/13 Sport 600's will max out around 600 whp at best so I - ztunerz 16:27:40 09/30/13 depends on the ethanol content - aliaZ 15:57:36 09/30/13 I was assuming 80 % or greater. We get that here so... (n/m) - ztunerz 16:24:34 09/30/13 I'd like to know also, for gt600s (n/m) - Krazyd27(Houston) 13:55:37 09/30/13 I made alil over 600whp just fine on my 485 with e85 (n/m) - Z32TT-R 01:17:08 10/01/13 More factors come into play... - Madhatter10-6 09:48:25 10/01/13 What dual pump setup do most go with? - Bumblebeetuna 10:57:51 10/01/13 Re: What dual pump setup do most go with? - Madhatter10-6 12:55:06 10/01/13 I am running a 485 pump, 600 turbos @ 25psi, 740 injectors - JDAVE 10:07:13 10/01/13 did you raise the fuel pressure? - Antihero 17:26:45 10/01/13
Post a Followup	You cannot reply to this message because you are not logged in.