Subject	Re: too lazy to look for the thread...
Posted by	rcmadness on September 26, 2013 at 3:20 PM
	This message has been viewed 502 times.
In Reply To	too lazy to look for the thread... posted by Antihero on September 24, 2013 at 07:32 PM
Message	I use an 88mm plate size on the flow bench and 1mm oversized valves worked best for me. I did deshroud the valve right up to the gasket surface which is common practice.
Follow Ups	How much better do 48p heads flow than 40p? - fuzzymonkey 15:32:33 09/24/13 Re: How much better do 48p heads flow than 40p? - rcmadness 15:55:36 09/24/13 Re: How much better do 48p heads flow than 40p? - Tech@EPR 16:09:00 09/24/13 Am I the only one thinking - -Grimm- 16:44:34 09/24/13 Re: Am I the only one thinking - rcmadness 17:11:06 09/24/13 too lazy to look for the thread... - Antihero 19:32:41 09/24/13 Re: too lazy to look for the thread... - Tech@EPR 06:34:52 09/25/13 A few questions - ZXoltan 14:24:03 09/25/13 Re: A few questions - Tech@EPR 00:18:07 09/26/13 What's it got to do with overlap? - ZXoltan 06:11:16 09/26/13 Re: What's it got to do with overlap? - Tech@EPR 15:05:15 09/26/13 Re: too lazy to look for the thread... - rcmadness 15:20:19 09/26/13 they don't (n/m) - aliaZ 18:39:31 09/24/13 Clearly you're wrong. (n/m) - Bernie (NoVA) 22:28:11 09/24/13 nope (n/m) - aliaZ 00:34:17 09/25/13 Re: nope - rcmadness 15:21:28 09/26/13
Post a Followup	You cannot reply to this message because you are not logged in.