TwinTurbo.NET: Nissan 300ZX forum - MSP Manifolds and My Build
People Seeking Info
 
   


     
Subject MSP Manifolds and My Build
     
Posted by esimplx on September 26, 2013 at 3:09 PM
  This message has been viewed 545 times.
     
     
Message Ok, so I my engine is in, wiring done, fuel system connected and exhaust in. But I have not hooked up the intake, intercoolers or radiator.

I have a long list of mods but essentially I have precision turbo 4828's with ash planar intake, 2.5" piping and intercoolers. (4828 is equivalent to disco potatoe) But a lack of experience when I was putting the engine together means I used stock manifolds.
The question is, is it worth pulling the engine back out, plus the $700, to make the swap, or should I get her tuned and just wait until something else comes up? How much of a difference will it make to my build?

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.