Subject	Re: I disagree. It is too thin of a skirt coming off of the
Posted by	Tech@EPR on September 24, 2013 at 2:17 PM
	This message has been viewed 250 times.
In Reply To	I disagree. It is too thin of a skirt coming off of the posted by Ash's Z on September 24, 2013 at 10:04 AM
Message	Pin fit the pistons for extra clearance. You wont have that issue anymore. Built dozens of engines with Wisecos...never a cracked skirt or pin bore housing. Not once. So as I stated...machining tolerances Ep Racing | Create Your Badge
Follow Ups	Opinions on JUN C-Series pistons - Rob260 08:59:40 09/23/13 i thought acl makes bearings, didn't know they made pistons - vulcanrush 12:04:16 09/23/13 Re: i thought acl makes bearings, didn't know they made pistons - Rob260 17:15:59 09/23/13 Go with CP..... (n/m) - Ash's Z 12:52:56 09/23/13 Why? (n/m) - Rob260 17:16:25 09/23/13 they seem to be the best pistons you can (readily) buy - vulcanrush 19:45:21 09/23/13 Yup, all points Kyle made when I was building my block (n/m) - vorpalZ 21:05:53 09/23/13 Re: they seem to be the best pistons you can (readily) buy - Tech@EPR 00:33:13 09/24/13 i thought wiseco pistons weren't 2618 alloy, hence they're - vulcanrush 09:07:35 09/24/13 Because they are designed better... - Ash's Z 08:28:28 09/24/13 Re: Because they are designed better... - Tech@EPR 08:52:45 09/24/13 I disagree. It is too thin of a skirt coming off of the - Ash's Z 10:04:41 09/24/13 Re: I disagree. It is too thin of a skirt coming off of the - Tech@EPR 14:17:55 09/24/13 You just haven't put enough power or miles through them - Ash's Z 18:05:16 09/24/13 Re: You just haven't put enough power or miles through them - Tech@EPR 19:08:42 09/24/13 Wasn't a pin bore failure, it is cracking in the skirt where - Ash's Z 10:18:23 09/25/13 Re: Wasn't a pin bore failure, it is cracking in the skirt where - Tech@EPR 11:55:18 09/25/13 Re: Wasn't a pin bore failure, it is cracking in the skirt where - Tech@EPR 16:59:52 09/25/13 Re: Opinions on JUN C-Series pistons - Rob260 17:44:05 09/23/13 Re: Opinions on JUN C-Series pistons - Tech@EPR 19:33:29 09/23/13 Re: Re: Opinions on JUN C-Series pistons - Rob260 19:47:26 09/23/13 Re: Re: Re: Opinions on JUN C-Series pistons - MikeC(NZ) 05:50:37 09/24/13
Post a Followup	You cannot reply to this message because you are not logged in.