Subject	Re: they seem to be the best pistons you can (readily) buy
Posted by	Tech@EPR on September 24, 2013 at 12:33 AM
	This message has been viewed 335 times.
In Reply To	they seem to be the best pistons you can (readily) buy posted by vulcanrush on September 23, 2013 at 07:45 PM
Message	They are made from the same 2618 ally forging. No difference. CP doesnt have an offset pin bore like Wiseco does. You can reference my comparison write up for further details Ep Racing | Create Your Badge
Follow Ups	Opinions on JUN C-Series pistons - Rob260 08:59:40 09/23/13 i thought acl makes bearings, didn't know they made pistons - vulcanrush 12:04:16 09/23/13 Re: i thought acl makes bearings, didn't know they made pistons - Rob260 17:15:59 09/23/13 Go with CP..... (n/m) - Ash's Z 12:52:56 09/23/13 Why? (n/m) - Rob260 17:16:25 09/23/13 they seem to be the best pistons you can (readily) buy - vulcanrush 19:45:21 09/23/13 Yup, all points Kyle made when I was building my block (n/m) - vorpalZ 21:05:53 09/23/13 Re: they seem to be the best pistons you can (readily) buy - Tech@EPR 00:33:13 09/24/13 i thought wiseco pistons weren't 2618 alloy, hence they're - vulcanrush 09:07:35 09/24/13 Because they are designed better... - Ash's Z 08:28:28 09/24/13 Re: Because they are designed better... - Tech@EPR 08:52:45 09/24/13 I disagree. It is too thin of a skirt coming off of the - Ash's Z 10:04:41 09/24/13 Re: I disagree. It is too thin of a skirt coming off of the - Tech@EPR 14:17:55 09/24/13 You just haven't put enough power or miles through them - Ash's Z 18:05:16 09/24/13 Re: You just haven't put enough power or miles through them - Tech@EPR 19:08:42 09/24/13 Wasn't a pin bore failure, it is cracking in the skirt where - Ash's Z 10:18:23 09/25/13 Re: Wasn't a pin bore failure, it is cracking in the skirt where - Tech@EPR 11:55:18 09/25/13 Re: Wasn't a pin bore failure, it is cracking in the skirt where - Tech@EPR 16:59:52 09/25/13 Re: Opinions on JUN C-Series pistons - Rob260 17:44:05 09/23/13 Re: Opinions on JUN C-Series pistons - Tech@EPR 19:33:29 09/23/13 Re: Re: Opinions on JUN C-Series pistons - Rob260 19:47:26 09/23/13 Re: Re: Re: Opinions on JUN C-Series pistons - MikeC(NZ) 05:50:37 09/24/13
Post a Followup	You cannot reply to this message because you are not logged in.