TwinTurbo.NET: Nissan 300ZX forum - upon looking at the DP's .... i dont think they are SZ's
People Seeking Info
 
   


     
Subject upon looking at the DP's .... i dont think they are SZ's
     
Posted by genic on September 15, 2013 at 12:31 PM
  This message has been viewed 239 times.
     
In Reply To ?, bde engine mounts and SZ downpipes/SZ testpipes posted by genic on September 14, 2013 at 08:56 PM
     
Message so i think they are the problem.

i dont really need to tranny exhaust hangers anyway. i have flex joints right after the DP's, and i am putting in flex joints right before the x-pipe ...so the exhaust as a whole will not be so rigid and cause any undo stress on the turdbowls. ...plus my b&b quad ovals line up perfectly and are less than a degree off level (un-noticeable)

...so i was just curious with this question. not bad mouthing bde's motor mounts (i didnt even know i had them until after this little fender bender i had)


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.