Subject	I used a 90° die grinder with various pads and bits to
Posted by	Hatchet502 on September 07, 2013 at 1:03 AM
	This message has been viewed 212 times.
In Reply To	Plenum turned out great! posted by bartz32tt on September 06, 2013 at 10:40 PM
Message	Take it down, then buffing wheels to polish it. The walls in between the channels were the hardest to clean up. Very tedious work
Follow Ups	Build pics - Hatchet502 21:01:46 09/06/13 Looking good. - ChaseGrayTT 21:38:54 09/06/13 Plenum turned out great! - bartz32tt 22:40:31 09/06/13 I used a 90° die grinder with various pads and bits to - Hatchet502 01:03:42 09/07/13 If you decide to polish a plenum, you might find this handy - 240Z FeO2 09:56:00 09/07/13 Looked better with the stillen lip. Good job on the plenum (n/m) - DSM_EX-DRIVER 01:27:34 09/07/13 I kept it for a rainy day, I like it more everytime I see it (n/m) - Hatchet502 14:40:13 09/07/13 Yep. Stillen lip or j spec are the only options that belong - DSM_EX-DRIVER 23:45:07 09/07/13 I do believe I concur, sir. (n/m) - Mike TDK (NoVA) 06:59:22 09/08/13 Great work, keep pushing (n/m) - ZaXxon 06:44:45 09/07/13 nice work... id like to do the same! (n/m) - 300ZMang 09:18:22 09/07/13 I like it! (n/m) - ConVerTT 09:42:52 09/07/13 Re: Build pics - traderwazz 11:02:57 09/07/13 Its a Wiring Specialties harness from CZP - Hatchet502 14:42:26 09/07/13 Nice progress - RobZ32 11:11:24 09/07/13 Way to make it yours my man. Keep up the great work. (n/m) - TTZ2NV(EPTmotorsports) 02:03:11 09/08/13 Nice work. Yeah, intake polishing is a ton of work. (n/m) - Boosted1 07:07:31 09/08/13
Post a Followup	You cannot reply to this message because you are not logged in.