Subject	Top Feed Fuel Rail Design
Posted by	Bad Fish on August 27, 2013 at 6:00 PM
	This message has been viewed 433 times.
Message	I have been looking at the BDE fuel rail kits for some time now. Brett recently started offering the ID 1300 injectors (for e85 compatibility). These new injectors are very short, maybe another 1/4 to 1/2" shorter than the 1000, and 2000cc variants. It got me thinking about building a top feed fuel rail that would fit under the plenum. The more I look at it, the more I think that a low profile fuel rail and the shorter 1300cc injectors would fit under the runners without issue. It may take a fuel rail that is offset or low profile. Just wondering if anyone else has considered a set up like this? May not be much benefit other than looking cleaner and fitting strut braces. Any thoughts?
Follow Ups	Top Feed Fuel Rail Design - Bad Fish 18:00:20 08/27/13 Re: Top Feed Fuel Rail Design - team7 18:16:35 08/27/13 Yes, the ID1300s are shorter, but I don't think an under - - LitlElvis 18:20:58 08/27/13 If you could I would buy them now :) (n/m) - Piranha 19:05:53 08/27/13 Re: Top Feed Fuel Rail Design - BLACKBEAST 23:34:58 08/27/13 I did it. Not for the faint of heart... - kkrofft (OH) 05:41:52 08/29/13
Post a Followup	You cannot reply to this message because you are not logged in.