Subject	If your as meticulous as u say and I am as well I would
Posted by	LivinTheDream on August 22, 2013 at 11:14 PM
	This message has been viewed 208 times.
In Reply To	What Mitch from EPRacing has to say. posted by LivinTheDream on August 22, 2013 at 11:01 PM
Message	think you'd want a builder with all the needed tools and more to ensure the assembly is as if it were fresh out of the factory or better. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	repost -Engine rebuild? - Zvil (FL) 11:49:19 08/21/13 If it isn't broke, don't fix it, lol. Install the parts on - TTZ2NV(EPTmotorsports) 12:00:47 08/21/13 Yes he did but he did replace the main and rod bearings - Evan_Wright (Ca) 12:32:48 08/21/13 dont touch it the engine. - rmp459 12:09:21 08/21/13 Repost...? When/where did you post originally? - ZXoltan 14:18:48 08/21/13 repost because there are several "should I rebuild" posts - Zvil (FL) 15:36:08 08/21/13 no way I would do it - LJZTT 15:07:06 08/21/13 Replace the rod bearings at a minimum. (n/m) - michaell32 (FL) 15:09:58 08/21/13 Re: repost -Engine rebuild? - slicktt 09:59:34 08/22/13 Need to totally disassemble to check ring gaps. - ZXoltan 10:24:49 08/22/13 Re: Need to totally disassemble to check ring gaps. - slicktt 10:35:59 08/22/13 Stuck lifter may cause LOSS of compression - ZXoltan 12:12:24 08/22/13 that's kinda what I was poking at - Zvil (FL) 12:20:47 08/22/13 Re: Stuck lifter may cause LOSS of compression - slicktt 12:40:11 08/22/13 Would an oil pressure test and oil analysis be enough? - Zvil (FL) 12:26:38 08/22/13 Your first sentence is a fairly common sentiment here (which - LJZTT 12:00:49 08/22/13 my example is a poor one - LJZTT 12:06:34 08/22/13 Re: Your first sentence is a fairly common sentiment here (which - slicktt 12:47:43 08/22/13 I will admit though - slicktt 12:51:37 08/22/13 this is my point - LJZTT 15:44:45 08/22/13 What Mitch from EPRacing has to say. - LivinTheDream 23:01:21 08/22/13 More: - LivinTheDream 23:10:22 08/22/13 If your as meticulous as u say and I am as well I would - LivinTheDream 23:14:23 08/22/13
Post a Followup	You cannot reply to this message because you are not logged in.