TwinTurbo.NET: Nissan 300ZX forum - Repost...? When/where did you post originally?
Subject
Repost...? When/where did you post originally?
Posted by
ZXoltan
on August 21, 2013 at 2:18 PM
This message has been viewed
201
times.
In Reply To
repost -Engine rebuild?
posted by Zvil (FL)
on August 21, 2013 at 11:49 AM
Message
what are the compression numbers on your engine now?
Follow Ups
repost -Engine rebuild?
-
Zvil (FL)
11:49:19 08/21/13
If it isn't broke, don't fix it, lol. Install the parts on
-
TTZ2NV(EPTmotorsports)
12:00:47 08/21/13
Yes he did but he did replace the main and rod bearings
-
Evan_Wright (Ca)
12:32:48 08/21/13
dont touch it the engine.
-
rmp459
12:09:21 08/21/13
Repost...? When/where did you post originally? -
ZXoltan
14:18:48 08/21/13
repost because there are several "should I rebuild" posts
-
Zvil (FL)
15:36:08 08/21/13
no way I would do it
-
LJZTT
15:07:06 08/21/13
Replace the rod bearings at a minimum. (n/m)
-
michaell32 (FL)
15:09:58 08/21/13
Re: repost -Engine rebuild?
-
slicktt
09:59:34 08/22/13
Need to totally disassemble to check ring gaps.
-
ZXoltan
10:24:49 08/22/13
Re: Need to totally disassemble to check ring gaps.
-
slicktt
10:35:59 08/22/13
Stuck lifter may cause LOSS of compression
-
ZXoltan
12:12:24 08/22/13
that's kinda what I was poking at
-
Zvil (FL)
12:20:47 08/22/13
Re: Stuck lifter may cause LOSS of compression
-
slicktt
12:40:11 08/22/13
Would an oil pressure test and oil analysis be enough?
-
Zvil (FL)
12:26:38 08/22/13
Your first sentence is a fairly common sentiment here (which
-
LJZTT
12:00:49 08/22/13
my example is a poor one
-
LJZTT
12:06:34 08/22/13
Re: Your first sentence is a fairly common sentiment here (which
-
slicktt
12:47:43 08/22/13
I will admit though
-
slicktt
12:51:37 08/22/13
this is my point
-
LJZTT
15:44:45 08/22/13
What Mitch from EPRacing has to say.
-
LivinTheDream
23:01:21 08/22/13
More:
-
LivinTheDream
23:10:22 08/22/13
If your as meticulous as u say and I am as well I would
-
LivinTheDream
23:14:23 08/22/13
Post a
Followup
You cannot reply to this message because you are not
logged in
.