Subject	TwinZ nose panel installation with OEM bracket
Posted by	flash-to-pass on August 14, 2013 at 7:49 PM
	This message has been viewed 545 times.
Message	The TwinZ nose panel arrived, good quality. It is drilled for use with the huge metal bracket that secures the forward edge of the OEM nose panel to the crossmember with two screws. When I transferred the bracket to the TwinZ panel (I had to slightly oversize the panel holes to line it up with the bracket; minus .5 point) I couldn't install the panel without distorting it to the point of nearly closing the slot. The bracket seems too high/curved to fit the panel. I temp installed the panel without it and it fits ok but the forward edge is loose. Anyone experience this? I tried to flatten the bracket by applying my 200 pounds of bulk to it and it didn't budge. You are supposed to retain the bracket, right?
Follow Ups	TwinZ nose panel installation with OEM bracket - flash-to-pass 19:49:19 08/14/13 Which cars came with that bracket anyway? (n/m) - LivinTheDream 21:20:02 08/14/13 Im thinking air bag models only, not certain (n/m) - Whip 22:22:32 08/14/13 91-96 w. airgbags (n/m) - Bernie (NoVA) 08:59:44 08/15/13 Re: TwinZ nose panel installation with OEM bracket - flash-to-pass 05:55:51 08/15/13 The forward edge should be secured by the bracket in front - ZXoltan 10:04:51 08/15/13 Re: The forward edge should be secured by the bracket in front - flash-to-pass 20:09:50 08/15/13
Post a Followup	You cannot reply to this message because you are not logged in.