Subject	You're going to need to do the JB weld hole saw mod
Posted by	zgene4 on August 07, 2013 at 2:23 PM
	This message has been viewed 173 times.
In Reply To	Which clear/smoked corners fit easiest with Ash Massives US posted by SMAZ (OKC) on August 07, 2013 at 10:23 AM
Message	to relocate the bulb and harness connector. There was a post not to long ago where I posted pictures of how I did it, then either Woody or Aliaz replied with their solution, which was a simpler approach in my opinion. WARNING: I lack industry backing
Follow Ups	Which clear/smoked corners fit easiest with Ash Massives US - SMAZ (OKC) 10:23:26 08/07/13 You're going to need to do the JB weld hole saw mod - zgene4 14:23:20 08/07/13 found it - zgene4 14:26:31 08/07/13 I got away with it - ZiNnYc 18:08:03 08/07/13 My JSPEC smoked fit fine... - Z ONLY1 21:26:05 08/07/13 on a-spec SZ had to cut my OEM clear corners for it to clear - WE350Z 22:55:52 08/07/13
Post a Followup	You cannot reply to this message because you are not logged in.