Subject	Re: Re: Follow up on the oil sandwich adapter leak
Posted by	RZturbo on July 24, 2013 at 10:34 PM
	This message has been viewed 166 times.
In Reply To	Re: Follow up on the oil sandwich adapter leak posted by Turbodog (CT) on July 24, 2013 at 05:53 PM
Message	It's a 90 degree NPT to AN fitting. So when I tightened it down, I had to turn it back a few degrees to get the AN hose positioned correctly in the tight space. It hardly had any thread left outside from looking at it. Now I'm thinking maybe the port was tapped out too wide originally.
Follow Ups	Follow up on the oil sandwich adapter leak - RZturbo 21:49:39 07/23/13 sidebar: which of our vendors sell sandwich adapters? - Inzane 10:30:12 07/24/13 Re: Follow up on the oil sandwich adapter leak - Bigwill837 11:15:04 07/24/13 Re: Re: Follow up on the oil sandwich adapter leak - RZturbo 22:37:05 07/24/13 Re: Follow up on the oil sandwich adapter leak - Turbodog (CT) 17:53:41 07/24/13 Re: Re: Follow up on the oil sandwich adapter leak - RZturbo 22:34:05 07/24/13 Try using red locktite instead of teflon tape. (n/m) - Turbodog (CT) 14:16:41 07/26/13
Post a Followup	You cannot reply to this message because you are not logged in.