Subject	leaving space....
Posted by	Todd Baugh on July 24, 2013 at 2:15 PM
	This message has been viewed 192 times.
In Reply To	Working on my photoshop skillz posted by Jiro on July 24, 2013 at 05:20 AM
Message	If you plan on printing these in traditional sizes (4x6, 8 x10), etc...you will want to leave some space on the sides to allow for the cropping down that these sizes bring. Otherwise you must print long sizes such as 11 x 17, etc to make sure it prints edge to edge. Todd Baugh
Follow Ups	Working on my photoshop skillz - Jiro 05:20:26 07/24/13 Close the door & hood in first shot & that is poster worth (n/m) - Boosted1 07:30:54 07/24/13 Also leave a little breathing room around the subject(s) (n/m) - SWhiteTT(GA) 07:34:46 07/24/13 I am going to say Canon with a 1.8f 50mm - Carlos Ramirez 08:06:34 07/24/13 its a canon 50mm it does go down to 1.8f :) - Jiro 10:54:32 07/24/13 polarizer. (n/m) - Halo TTZ 09:09:46 07/24/13 leaving space.... - Todd Baugh 14:15:20 07/24/13 Some feedback - BlackholeZ 15:47:09 07/24/13 I want to know all dimensions on z32 wheel/tires, great look (n/m) - whitepearl 19:58:44 07/24/13 thanks for the input here is the first remastered :) - Jiro 23:03:06 07/24/13 Much better framing. Thanks! (n/m) - SeedyROM 23:22:43 07/24/13 It's a tad too "red" as in the 1st try. (n/m) - SWhiteTT(GA) 08:33:13 07/25/13 That's better, I see why you cropped it so tight - BlackholeZ 10:56:32 07/25/13 i love this. 100% better to me. - Halo TTZ 02:08:24 07/26/13
Post a Followup	You cannot reply to this message because you are not logged in.