Subject	Re: Follow up on the oil sandwich adapter leak
Posted by	Bigwill837 on July 24, 2013 at 11:15 AM
	This message has been viewed 182 times.
In Reply To	Follow up on the oil sandwich adapter leak posted by RZturbo on July 23, 2013 at 09:49 PM
Message	Which Sandwhich adapter plate are you using? Mocal? I'm not sure from your post where you think you're getting a leak from. The ports where the oil lines enter/exit the sandwich plate to run to your oil cooler? I know some of the sandwhich plates use exclusively BSP or NPT threads (not sure which). I believe NPT is tapered. I would check to make sure you've got the correct fittings and that it's not leaking at the transition from the ports to the fitting or the fitting to the -AN lines. This might help too: [ http://97.74.32.155/files/sp1t.pdf ]
Follow Ups	Follow up on the oil sandwich adapter leak - RZturbo 21:49:39 07/23/13 sidebar: which of our vendors sell sandwich adapters? - Inzane 10:30:12 07/24/13 Re: Follow up on the oil sandwich adapter leak - Bigwill837 11:15:04 07/24/13 Re: Re: Follow up on the oil sandwich adapter leak - RZturbo 22:37:05 07/24/13 Re: Follow up on the oil sandwich adapter leak - Turbodog (CT) 17:53:41 07/24/13 Re: Re: Follow up on the oil sandwich adapter leak - RZturbo 22:34:05 07/24/13 Try using red locktite instead of teflon tape. (n/m) - Turbodog (CT) 14:16:41 07/26/13
Post a Followup	You cannot reply to this message because you are not logged in.