Subject	Just saw Z1's instructions.
Posted by	90GoldZ on July 21, 2013 at 8:40 AM
	This message has been viewed 255 times.
In Reply To	Yeah, finally figured that out as well as having the wrong posted by SMAZ (OKC) on July 20, 2013 at 11:37 PM
Message	Heat the metal flange and turn it, or heat it and turn it until it is loose, and pull it from the valve body. Don't bother cutting the lower part if you're doing your install like that one. Woody's solution for z1 pipes Woody's solution for ash/coz piping
Follow Ups	Pics needed for Ash Spec intercooler piping install - SMAZ (OKC) 18:22:09 07/20/13 Where are you hung up? - z-u-later 22:43:06 07/20/13 Yeah, finally figured that out as well as having the wrong - SMAZ (OKC) 23:37:46 07/20/13 You have to cut the aluminum elbow. - 90GoldZ 07:51:48 07/21/13 Re: You have to cut the aluminum elbow. - wild_maxx 08:09:32 07/21/13 Just saw Z1's instructions. - 90GoldZ 08:40:43 07/21/13 Thanks very much! This gives me some ideas and links - SMAZ (OKC) 10:31:35 07/21/13 At the very least, install the turbo inlets. - 90GoldZ 10:55:05 07/21/13
Post a Followup	You cannot reply to this message because you are not logged in.