Subject	Re: You have to cut the aluminum elbow.
Posted by	wild_maxx on July 21, 2013 at 8:09 AM
	This message has been viewed 447 times.
In Reply To	You have to cut the aluminum elbow. posted by 90GoldZ on July 21, 2013 at 07:51 AM
Message	As GoldZ mentioned, you may need to cut off the 90* on the recirc valve aluminum side then clock the 90* steel side. I was able to use the OEM recirc hoses after some trimming. A BDE GHK kit will be installed and I'll use 90* fittings on the vacuum port on top.
Follow Ups	Pics needed for Ash Spec intercooler piping install - SMAZ (OKC) 18:22:09 07/20/13 Where are you hung up? - z-u-later 22:43:06 07/20/13 Yeah, finally figured that out as well as having the wrong - SMAZ (OKC) 23:37:46 07/20/13 You have to cut the aluminum elbow. - 90GoldZ 07:51:48 07/21/13 Re: You have to cut the aluminum elbow. - wild_maxx 08:09:32 07/21/13 Just saw Z1's instructions. - 90GoldZ 08:40:43 07/21/13 Thanks very much! This gives me some ideas and links - SMAZ (OKC) 10:31:35 07/21/13 At the very least, install the turbo inlets. - 90GoldZ 10:55:05 07/21/13
Post a Followup	You cannot reply to this message because you are not logged in.