Subject	Yeah, finally figured that out as well as having the wrong
Posted by	SMAZ (OKC) on July 20, 2013 at 11:37 PM
	This message has been viewed 304 times.
In Reply To	Where are you hung up? posted by z-u-later on July 20, 2013 at 10:43 PM
Message	rear intercooler pipe I was trying to make work. Cleared the sheet metal hole with a hammer so I've got the driver side installed. I ran across Z1's instructions about swapping factory recircs around and inverting them. How do I get the elbow off? I tried for a bit with a dead blow and even a chisel and I'm afraid I'm going to break it. Bought new silicone hoses, but now they're not lining up. 1996 TT #61 of 300
Follow Ups	Pics needed for Ash Spec intercooler piping install - SMAZ (OKC) 18:22:09 07/20/13 Where are you hung up? - z-u-later 22:43:06 07/20/13 Yeah, finally figured that out as well as having the wrong - SMAZ (OKC) 23:37:46 07/20/13 You have to cut the aluminum elbow. - 90GoldZ 07:51:48 07/21/13 Re: You have to cut the aluminum elbow. - wild_maxx 08:09:32 07/21/13 Just saw Z1's instructions. - 90GoldZ 08:40:43 07/21/13 Thanks very much! This gives me some ideas and links - SMAZ (OKC) 10:31:35 07/21/13 At the very least, install the turbo inlets. - 90GoldZ 10:55:05 07/21/13
Post a Followup	You cannot reply to this message because you are not logged in.